Восстановление RAID на Sil 3112

Обсуждения проблем с железом. Полезные советы по теме.


Модератор: UncleFather

Аватара пользователя
UncleFather
Site Admin
Сообщения: 1503
Зарегистрирован: 17 авг 2004 16:20, Вт
Контактная информация:

Восстановление RAID на Sil 3112

Сообщение UncleFather »

Получилось так, что после замены винта в рейд-массиве, после перезагрузки комп отказался грузиться с рейда. Говорит типа Set 0 Invalid Raid Drive.
Беру чистый винт. Ставлю в этот комп (без рейд-контроллера), ставлю на него ХП-шку, ставлю дрова РЕЙД-контроллера, ставлю виндошную утилитку от РЕЙД-контроллера, подключаю к контроллеру один винт старый и один винт новый, из-под виндов конфигурирую 1-й рейд заново, при этом указываю, что данные брать с моего старого диска. Все заработало.

Добавлено спустя 2 минуты 4 секунды:

В догонку

На www.siliconimage.com описано, что, если один из НЖМД упал в состояние "dropped", то его нужно вывести из массива, а затем снова зарулить в массив и сделать ребилд.

Вот оригинал:
IDE/RAID: Rebuilding a RAID Set
Make sure the Windows RAID Management software is installed on your computer. (The latest version can be downloaded on our website. For 649, this is called “Medley”, for 680 this is called “SiICfg, for 3112, this is called “SATARAID”)

Open the Windows user-interface utility and on the left hand side, use your mouse to select “Set 0”. Similarly, on right hand side, use your mouse to select “Members”. When the mirror is functioning properly, the status of both drives will be current. If the mirror is broken or degraded, the status will be either “dropped” or “rebuilding”.

Using your mouse, select the drive that has been “dropped” and remove from the RAID set by clicking the “Remove” key in the “Members” field of “Set 0”.

On the left hand side of the utility, use your mouse to select the drive that was previously removed (ie secondary master) and add back to the RAID set by dragging and dropping the selected drive to the “Set 0”, “Members” field. The previously removed drive will now appear in the “Members” field and an immediate rebuild will commence. (see screenshot download on right)

Once the rebuild has been completed, both drives in the RAID set will return to “current” status.

И еще один:
IDE/RAID: RAID 0+1 Partition Not Setup
This message indicates that the mirror in the RAID 0+1 set is broken and needs to be rebuilt. Open your Medley RAID manager and locate the Set Information section. This should tell you what the nature of the problem is. You may need to remove the failed drive from the RAID set, and then add it back in to rebuild the mirror.


Alexander A. Manaeff©

Понравилась статья? Будем крайне признательны за репосты в соцсетях! Материально поддержать проект можно здесь

Мои странички:
ВКонтакте
Одноклассники
Youtube
Facebook
Instagram

Изображение
Изображение
Изображение
Изображение